Bazsux: HOW TO: Recycle a sweater into a cuddly pillow for your couch

2016. november 11., péntek

HOW TO: Recycle a sweater into a cuddly pillow for your couch

Making pillows out of old sweaters is easy to do, and has the double bonus of upcycling materials, and making your house even cozier.

What You'll Need:

Two old sweaters, large enough to fit your desired pillows (if you don’t have any old sweaters in your closet, try a thrift shop. Wash and dry the sweaters before you start.)
Two or more throw pillows with their slipcovers removed
Sewing machine
Thread, scissors, pins, needles, colored pencil or chalk, ruler or measuring tape
Four buttons

Button Pillow Step 1: Measure and Mark

For the buttoned pillowcase, start by smoothing out and pinning together the two sides of the bottom hem – this will form the opening of the pillowcase. Pinning will keep the sweater hem from stretching out and getting misshapen when you sew it.

With a colored pencil or chalk, use a ruler or measuring tape to mark out a square that is approximately ½ inch larger than your pillow measurements on all sides. For the button pillow, we only needed to cut two sides of the sweater to create the right size square: the bottom hem forms the opening, and the right seam we left intact.

Button Pillow Step 2: Sew And Cut Sides

Using a wide straight stitch, slowly sew the seam you just marked on the two sides of the square, being cautious not to stretch the sweater too much, which can pucker the seam. Trim off the excess sweater material, close to the seam you just created.

Once you’ve cut out the complete square, finish the newly cut seam edges with a zig-zag or overlock stitch, to keep the sweater seam from unraveling.

Button Pillow Step 3: Add Buttons

Turn the pillow right-side out and remove the pins along the hem. Measure out and mark a spot for 4 equally spaced buttons along the inside edge hem of the sweater. Use a needle and thread to hand sew the buttons on. Next, mark out four corresponding spots on the upper hem with a pin. Using scissors, snip a tiny hole and unravel it just large enough for each button. Use a needle and thread to hand sew the edge of the buttonhole so the yarn doesn't continue to unravel.

Button Pillow Step 4: Finish Pillow

Place the pillow inside the new pillowcase and button it shut – you’re done!

Envelope Pillow Step 1: Measure and Mark

Unlike the button pillow, you’ll be cutting three pieces for this version. Start by using a colored pencil or chalk and a ruler to mark out a square that is approximately ½ inch larger than your pillow measurements on just the front half of the sweater (or the part you intend to use for the front of the pillow). Cut this piece out, but be careful not to cut through both layers like you did for the button pillow

Next, measure out two overlapping pieces – we used the sweater’s border here – to form the envelope back. The two pieces must overlap at least 3-5 inches, and when overlapped, should form the same measurements as above (a square approximately ½ inch wider than the pillow measurements).

Envelope Pillow Step 2: Create Pillow Back

Pin together the envelope back with the two pieces overlapped 3-5 inches. Ensure that you have them aligned evenly, then pin securely together. Stitch the side seams together just where the two pieces overlap.

Envelope Pillow Step 3: Sew Pillow Together

Place the two pieces together, right sides together, and pin securely. Slowly sew all four edges of the pillow together using a wide straight stitch, moving slowly so as not to pucker the fabric too much. Finish the edges of all four seams with a zig zag stitch to prevent the sweater from unraveling.